CRYO-S Electric II

CRYO-S ® Electric II is state-of-the-art cryosurgical device manufactured by METRUM CRYOFLEX is the next generation of apparatus used in the surgery field since 1992. 

Mode selection probe, cleaning and freezing can be performed automatically using footswitch or convenient touch screen which allows to keep the site of a procedure under sterile conditions.

RFiD – electronic communication between the probe and device allows recognition of optimal operating parameters and auto-configures to cryoprobe characteristic. Pressure and gas flow are set automatically, any manual adjustment is not necessary.

Contains automatic cryoprobe test system and two freezing modes (continous and sequential). Probe test system includes autocleaning and short freezing test.

Built-in voice communication for easier work. System informing about key figures during procedure.

Pressure and gas flow are set automatically, any manual adjustment is not necessary. Automatic working modes (stop, preparation, ready, freezing, cleaning).

The working medium for CRYO-S ®  Electric II is carbon dioxide: CO2 (-78°C) or nitrous oxide: N2O (-89°C), very efficient and easy to use gases.

A 10 liter cylinder of CO2/N2O serves for approximately 60 procedures.

User friendly interface

CRYO-S ® Electric II is controlled by a microprocessor and all the parameters are displayed and monitored on a LCD screen. Cryoprobe temperature, cylinder pressure, gas flow inside of cryobrobe and procedure time are displayed during freezing.

30 years of experience

       CRYO-S ® Electric II state-of-the-art cryosurgical device manufactured by METRUM CRYOFLEX is the next generation of apparatus used by many experts in the field since 1992.

Cryoprobes which meet the highest standarts of quality

Wide range of contact cryoprobes – single and multiple use as well. Needle shaped cryoprobe is only 0,8 mm in diameter – excellent for treatment of intramucosal conchoplasty. Special construction enables precise freezing and fast defrosting.

High quality of cryoprobes which are cover with 24 carat gold.

Sterilization cryoprobe possible in autoclaves 134°C, 3 minutes

The wide range of cryoprobes for vitreous, retinaland and palpebrals.

Technical specification

  • Power requirements
    • Power 100÷240 V (50/60 Hz) AC
    • Maximum power consumption 150 VA
  • Cooling medium
    • CO2  -78°C or N2O  -89°C
    • Maximum pressure 70 bars (CO2) and 55 bars (N2O)
    • Working pressure 48÷65 bars (CO2), 38-53 bars (N2O)
  • LCD screen (touch)
  • Voice information system (information about key figures during procedure)
  • Comfortable foot switch controler (dual function).
  • Automatic/Manual control of the flow rate parameters
  • Automatic gas pressure control
  • Freezing temperature indicator
  • automatic working modes (stop, preparation, ready, freezing, cleaning)
  • Cryoprobe information system (information about type of probe used, number of treatments left for the specific probe)

Functional modes of unique cryoprobe prepairing system:

  • Standard Cryoprobe is cleaned before each procedure for several seconds and than few seconds of testing freezing is performed. In this mode cryoprobe is tested and prepared according to parameters programmed on attached microchip. When such preparation is finished cryoprobe is ready for freezing.
  • Service it starts automatically when decreased flow rate in cryoprobe or cryoprobe blockage is noticed. It can be performed also during the procedure. Service mode is diagnosing and solving problems caused by previous improper use of the cryoprobe, improperly performed sterilization or low quality of gas.

Specializations